Hewlett-Packard sx2000 Manual

A SERVICE OF

next previous

2. Remove the cardboard from the blower housing (Figure 3-13).

This cardboard protects the housing baffle during shipping. If it is not removed, the fans

can not work properly.

Figure 3-13 Removing Protective Cardboard from the Housing

NOTE: Double-check that the protective cardboard has been removed.

3. Using the handles on the housing labeled Blower 3 Blower 2, align the edge of the housing

over the edge at the top rear of the cabinet, and slide it into place until the connectors at the

back of each housing are fully mated (Figure 3-14). Then tighten the thumbscrews at the

front of the housing.

Figure 3-14 Installing the Rear Blower Housing

Setting Up the System 73