Figure 3-53 Attaching Rear Kick Plates
4. Perform steps 1–3 on the right kick plate.
5. Position the upper flange of the center kick plate under the I/O trays complementary
mounting bracket, to retain the center kick plate top flanges. No top screws are needed on
the center kick plate. Orient this asymmetrical bracket with the hole located nearest the edge
in the up position.
6. Using a T-20 driver, tighten the thumbscrews at the bottom of the center kick plate.
Performing a Visual Inspection and Completing the Installation
After booting the system, carefully inspect it and reinstall the EMI panels. To perform a final
inspection and complete the installation, follow these steps:
1. Visually inspect the system to verify that all components are in place and secure.
2. Check that the cables are secured and routed properly.
3. Check that the cell board ejectors are secure (Figure 3-54).
If the ejectors are broken or open, the cell board is disconnected.
110 Installing the System
