A SERVICE OF

logo

Connecting To The Network
61
Configuring The Print Server
Connecting To The Network
To attach the LineJet Print Server card to a network, plug the network cable
into the LineJet Print Server connector (see Figure 7).
Watch the LEDs in the rear of the printer as they cycle through the power on
self-test. When the test is complete, the STAT led will flash.
Figure 7. Physical Setup
Configuration Setup
There are two parts to a LineJet Print Server setup:
1. Configuring the LineJet Print Server card so it can be seen on the
network. This involves network related settings (e.g., an IP address within
TCP/IP environments) configured through the built-in command shell,
npsh, or from the control panel.
Network Connector
$
$