Diagnostics
125
Test Width
This parameter permits you to run the self-tests at full width or 80 columns.
Paper Out Dots
It is recommended that only a Hewlett-Packard Customer Service Engineer
set this parameter.
Paper Out Dots allows the Customer Service Engineer to specify where the
last line on the page will print when there is a paper out condition. Setting this
parameter correctly prevents printing on the platen.
System Memory
This parameter displays the amount of RAM installed.
Print Statistics
You can view various printer statistics, such as hours of usage, and refer to
these figures for preventive maintenance purposes. Printer statistics
accumulate continuously; they do not reset when you turn off the printer.
All of the printer statistics are set to zero at the factory after burn-in testing.
• On. The cumulative time in hours the printer has been powered on. The
range is from 0 to 30,000 hours.
• Print. The cumulative time in hours the printer has actually been printing.
The range is from 0 to 30,000 hours.
• Print Strokes. The cumulative number of back-and-forth shuttle strokes
the printer has printed during normal operation. The range is from 0 to
2,147,483,648 shuttle strokes.
• Print Lines. The cumulative number of lines the printer has printed. The
range is from 0 to 2,147,483,648 print lines.
• 11 inch Pages. The cumulative number of pages the printer has printed.
The range in print pages is from 0 to 2,147,483,648 total inches of paper
movement divided by 11.
Caution This parameter must match paper width used. If full width is selected
for use with 80-column or 8.5-inch wide paper, damage to the
hammer tips and platen may result.
