220
Chapter 12 Complete Command List
Command Prefixes
Typing in the first portion of a command will produce an error message
showing the correct syntax. For example, typing in
store tcpip will
produce a list of all commands that start with this prefix.
Complete Command List
This section outlines the entire LineJet Print Server command set including
the command syntax, a description, and, in most cases, an example for each
command listed.
Store Commands
These commands change the settings stored in flash memory and do not
affect the current or working settings in memory. A power cycle is needed
before the stored settings become current.
store ifc
ifnum
utp [-]li [-]rx
store ifc 1 utp li
Modify the physical UTP interface properties where li enables link
integrity and
rx enables the increased receive threshold.
store ifc from default
Set all UTP settings back to factory defaults.
store ifc from current
Store all current UTP settings to flash memory so they are retained after a
power cycle. This ensures all current settings match what is stored in
flash memory.
store pserver opts [[-]jobsecurity] [jobtimeout
seconds
]
store pserver opts jobsecurity jobtimeout 5
If jobsecurity is disabled, any user can cancel queued jobs on the
LineJet Print Server including guest users. If
jobtimeout is set to
some value other than 0, the LineJet Print Server will only wait this
amount of
seconds
when getting printer feedback. This is only used if
you have a logpath port and type set on a particular destination.
store pserver tcpsocket
TCPportnumber
port
newTCPportnumber
store pserver tcpsocket 4000 port 5000
Change a pre-defined
TCPportnumber
on the LineJet Print Server to a
newTCPportnumber
. The default number is 9100 for prn.
Note
If you see the word
ifnum
in any shell commands, you should substitute a
1 unless directed to do otherwise. This 1 represents the one network
interface (i.e., Ethernet) supported.
