Extron Electronics Ultra Series Manual

A SERVICE OF

next previous

Matrix Software, cont’d

CrossPoint / MAV Matrix Switchers • Matrix Software

5-6

Figure 5-6 — Sample program window (complete)

• TosetupaudioinFollow mode (audio and video have the same tie

conﬁguration), select the Follow box at the bottom of the window. To set up

audio in breakaway mode (audio and video have different tie conﬁgurations),

deselect the Follow box.

• Tomakethecontrolprogrameasiertouse,assignadeviceicontoeachinput

and output. Click on a box that represents an input or output, and drag the

desired icon onto the box from the icon palette that appears.

• Tocreateatie,draganinputboxtooneormoreoutputboxes.Toremovea

tie, drag the output box to its tied input box or to the trash can.

• Forquickdisplayofinformationonaspecicinputoroutputdevice,position

the cursor over that device in the control program window. The program

opens a window that details the connections to that device, the audio level,

the frequency of the video signal input from or output to that device, and, for

theCrossPointswitchersonly,theswitchinginterval(RGBdelay).Seethe

insetboxingure5-6.

• Ifdesired,onthetaskbar,clickTools>IP Optionstosettheswitcher’sIP

parametersintheIPSettings/Optionswindow(gure5-7).