A SERVICE OF

logo

Open as PDF
next previous
Programmer’s Guide, cont’d
CrossPoint / MAV Matrix Switchers • Programmer’s Guide
4-4
Ethernet (LAN) Port
The rear panel Ethernet connector on the switcher can be connected to an Ethernet
LAN or WAN. Communication between the switcher and the controlling device
isviaTelnet(aTCPsocketusingport23).TheTelnetportcanbechanged,if
necessary,viaSIS.ThisconnectionmakesSIScontroloftheswitcherpossibleusing
acomputerconnectedtothesameLANorWAN.TheSIScommandsandbehavior
of the product are identical to the commands and behavior the product exhibits
when you are communicating with it via a serial port.
Ethernet connection
The Ethernet cable can be terminated as a straight-through cable or a crossover
cableandmustbeproperlyterminatedforyourapplication(gure4-3).
• Crossover cable—Directconnectionbetweenthecomputerandthe
CrossPointorMAVPlusswitcher.
• Patch (straight-through) cable—ConnectionoftheCrossPointorMAVPlus
switcher to an Ethernet LAN.
Side
RJ-45
connector
Patch (straight) cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2Orange 2Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
Insert
twisted
pair wires.
Figure 4-3 — RJ-45 Ethernet connector pin assignments