Filter
Top Products
86 PSR-S970/S770 Owner’s Manual
4 Press one of the REGISTRATION MEMORY [1] – [8] buttons to
which you wish to memorize the panel setup.
The memorized button becomes red, which indicates the number button
contains data and its number is selected.
5 Register various panel setups to other buttons by repeating
steps 1 – 4.
The registered panel setups can be recalled by simply pressing the desired
number button.
You can save all eight registered panel setups as a single Registration Memory Bank file.
1 Press the REGIST BANK [+] and [-] buttons simultaneously to
call up the Registration Bank Selection Display.
2 Press the [6 ] (SAVE) button to save the Bank file.
For instructions on saving, refer to page 28.
NOTICE
If you select the button whose
lamp is lit in red or green here,
the panel setup previously mem-
orized to the button will be
erased and replaced by the new
settings.
About the lamp status
• Red: Data registered and currently selected
• Green: Data registered but not currently selected
• Off: No data registered
NOTE
The panel setups registered in the
numbered buttons are maintained even
when you turn off the power. If you
want to delete all the eight current
panel setups, turn the power on while
holding the B5 key (right-most B key
on the keyboard).
Saving the Registration Memory as a Bank file
Bank 01
Bank 02
Bank 03
Bank 04
2
NOTE
Make sure that MENU 2 is shown at
the bottom right corner of the display
(page 26).
12psrs970_en_om.book Page 86 Friday, June 26, 2015 3:33 PM