Filter
Top Products
SETUP
Use Stand Adapter
14 PINPAD 1000SE INSTALLATION GUIDE
Screw-Mounting
the Adapter
The stand adapter may also be screwed directly to a wall or countertop.
• Use screw anchors when fastening the adapter to a cement or brick wall.
• When fastening the plate to drywall, the screws must go into the studs behind
the wall. Screw anchors alone will not safely hold the adapter to drywall.
To screw-mount the stand adaptor, use American National Standard #8 or Metric
M3 screws, with head diameter between 4.5 and 6.0mm, and head thickness less
than 2.5mm. Use the stand adaptor to mark the hole placement on the desired
location, and then insert screws, adjust the screw depth until the unit is firmly
mounted.
Using the Stand
Adapter
Figure 6 shows how to insert a PINpad 1000SE unit into a stand adapter. Slide the
end of the PINpad 1000
SE unit into the bottom of the stand adapter, then press
the screen end of the PINpad 1000
SE unit firmly into the top of the stand adapter
until you hear and feel the release lever click.
Figure 6 Inserting the PINpad 1000
SE device into the Stand Adapter
Removal is simply the reverse: press the release lever at the top of the stand
adapter and pull the PINpad 1000
SE unit up and out of the stand adapter.