Filter
Top Products
SETUP
Use Stand Adapter
PIN
PAD 1000SE INSTALLATION GUIDE 13
1 Disconnect power from the PC/AT.
2 Connect the end of the cord with the DB25/DB9 connector to the PC/AT.
3 Connect the modular plug on the other end of the cord to the PINpad 1000SE
device.
4 Plug the power supply cord into the socket at the base of the PC/AT
connector.
5 Plug the power supply into an AC wall outlet.
6 Reconnect power to the PC/AT.
Use Stand
Adapter
The optional stand adapter holds the PINpad 1000SE unit securely to a countertop
or a wall. The unit can be removed from the stand adapter anytime for handheld
operation.
Mounting the
Adapter to Plate
Figure 5 shows how to install a stand adapter onto a pre-existing flat mounting
plate.
1 Select a location for the stand adapter on a smooth wall or countertop. Be
sure the cable can easily reach the controller from this position without
stretching.
2 Position the keyholes on the molded cradle over the slotted screws on
mounting plate. Slide the adapter downward until the screws are in the narrow
ends of the keyholes.
Figure 5 Stand Adapter Installation
CAUTION
Using an incorrectly rated power supply can damage the unit or cause it not to
work properly. VeriFone recommends using only VFN# CPS04951-xx but
supports VFN# CPS11220-3A if used with a country-specific power cord (see
Specifications for detailed power supply specifications).