Filter
Top Products
SETUP
Connect Unit to a PC/AT (optional)
12 PINPAD 1000SE INSTALLATION GUIDE
Figure 3 illustrates how to connect the PINpad 1000SE device to an Omni 37xx
series terminal. For other terminal or controller connections, refer to the reference
manual for that controller.
Figure 3 PINpad 1000
SE and Terminal Cable Connections
1 Disconnect power from the terminal.
2 Connect the modular plug on the cable to the modular jack on the rear of the
PINpad 1000
SE device.
3 Connect the other end of the cable to the PlNpad port on the rear of the
terminal.
4 Reconnect power to the terminal.
Connect Unit
to a PC/AT
(optional)
If the PINpad 1000SE device is going to be connected to an IBM PC/AT or
compatible for general use, or the PC/AT will be running MKIXOR software for key
insertion, VeriFone sells special cable products to provide power to run the
PINpad 1000
SE (refer to Accessories and Documentation). Figure 4 illustrates
how to connect the PINpad 1000
SE to an IBM AT or compatible computers.
Figure 4 PINpad 1000
SE and IBM AT Cable Connections
OMNI 37XX PINPAD 1000SE