Filter
Top Products
02
Use a double-sided tape to secure the bracket to
a desired position.
You can use the screws to tighten the camera. (not
included)
The double-sided tape cannot be reused after being
used once.
Keep the installation surface clean before attaching
the double-sided tape to the bracket.
Otherwise, the adhesive force may be deteriorated,
causing a fall of the camera.
Fit the protruding points (x2) of the bracket into the corresponding holes
of the camera before turning clockwise to fix the camera.
1.
n
`
`
`
2.
Place the camera in a desired position
on the surface.
Adjust the camera’s shooting angle as appropriate.
Do not put excessive force.
Otherwise, it may cause damage
to the camera.
If you use the camera in contact
with the base unit, this may
cause noise on the video. It is
advisable to use the camera in a
5º to 10º tilt.
Connect the power
cable.
When done, remove the protective film from the lens.
1.
2.
n
`
`
3.
n
`