Filter
Top Products
10
· English
Plug in the power cable and arrange the cables through the bracket
holes.
5.
Adjust the camera’s shooting angle as appropriate (left and right) and
tighten the screws on the bottom of the bracket.
You can also use a coin or flat-head screwdriver to tighten them.
Adjust the camera’s shooting angle (top
and bottom).
Do not put excessive force. Otherwise, it
may cause damage to the camera.
If you use the camera in contact with the
base unit, this may cause noise on the
video. It is advisable to use the camera in a
5º to 10º tilt.
3.
n
`
4.
n
`
`
When done, remove the protective film from the lens.
n
`
Plug-in the camera power adapter to the wall outlet and connect the camera as
shown.
Make sure to use the provided power adaptor. Otherwise, the product may not
operate properly.
It will take about 1min for the camera to boot-up completely.
When the boot-up is complete, the power LED color will change from red to white.
n
`
`
`