Filter
Top Products
Turn power switch off before conducting any maintenance procedures.
5
ASSEMBLY AND SET-UP
q Replacing the Wheels
WARNING: Failure to
properly adjust and tighten the
screws, nuts and bolts that affix
the wheels can cause you to lose
control and crash.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Loosen
Tighten
Front and rear wheel installation and removal are the same.
1 To remove a wheel, remove
the self-locking nut (13mm open
wrench required for front wheels,
17mm for the rear wheels). Tap the
wheel to remove.
2 Front Wheel: To replace a
front wheel, make sure the bearings
are seated and the center spacer is
installed. Position the wheel with
the Razor logo facing outward.
Install the washer and tighten the
self-locking nut securely.
2 Rear Wheel: To replace a
rear wheel, make sure the key is
properly seated in the rear axle and
aligned with the notch in the wheel.
Position the wheel with the Razor
logo facing outward. Install the
washer and tighten the self-locking
nut securely.
WARNING: Use
ONLY with the recommended
charger. Batteries are only to be
charged under adult supervision.
The charger is not a toy. Always
disconnect your Ground Force from
the charger before cleaning with
liquid.
The charger supplied with the
Ground Force should be regularly
examined for damage to the cord,
plug, enclosure and other parts.
In the event of such damage, the
Ground Force must not be charged
until it has been repaired or
replaced.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED to indicate the charge
status. Refer to the illustration
on the charger unit for the actual
“charging” and “charged” status
indications for your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Charger will get warm during use.
This is normal for some chargers
and is no cause for concern. If your
charger does not get warm during
use, it does not mean that it is not
working properly.
Charger
q Charging the Battery
Your Ground Force may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
2 Turn power OFF before
charging. Plug the charger into the
charger port to charge unit.
1 Plug the charger into a wall
outlet. If the lights on charger do
not light up, check the power to the
outlet. If necessary, try a different
outlet.
Note: Make sure power is turned
OFF when unit is not in use. If
the power switch is left on for an
extended period of time, the battery
may reach a stage at which it will
no longer hold a charge.
• Initialchargetime:12hours
• Rechargetime:12hours,evenifthelightturnsgreen.
• Fullychargebatterybeforestoring.
• Whenthescooterisnotinregularuse,recharge
the battery at least once a month until normal
use is resumed.
• Runtime:Upto40minutesofcontinuousridetime.
Run time may vary depending on riding conditions,
climate and/or proper maintenance.
• Averagebatterylife:250charge/dischargecycles
• Toensurelongbatterylife,donotstorethebattery
in temperatures above 75° or below -10° F.
Charger