Razor 300001-SL Riding Toy User Manual


 
Turn power switch off before conducting any maintenance procedures.
1 Using a 5mm Allen wrench, loos-
en and remove the screw located in
the steering column.
2 Make sure wires are not
tangled. Insert the steering wheel,
washer and screw into the steering
column as shown.
3 Tighten screw securely using a
5mm Allen wrench.
3
ASSEMBLY AND SET-UP
q Attaching the Steering Wheel
q Attaching the Seat
WARNING: Failure to
properly install and tighten the
screws, nuts and bolts that affix the
steering wheel and seat can cause
you to lose control and crash.
WARNING: DO NOT
flip the Ground Force upside down
to tighten steering axle bolts as it
may damage control wires from the
steering wheel.
WARNING: The lap
belt arrangement supplied with
the Ground Force is for “play” use
only. It is not an ASTM-approved
lap belt system and is not intended
to function as an approved lap/
shoulder/seat restraining device.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
1 Position the seat over the frame
and align it with the holes in the
frame. Align the safety belt anchor
holes to the holes in the seat
and frame with the lap/shoulder
assembly on the left and the
receiver latch on the right. Insert
the screws and tighten securely.
2 Install the shoulder belt anchor
to the back of the seat. Insert and
tighten securely.