Filter
Top Products
Getting your baby monitor ready
Baby Unit
• Connect the AC power adapter (7) to an AC mains socket, and then
connect the cord to the DC power supply socket (2) of the Baby Unit.
Note:To switch off the Baby Unit completely, press the POWER button (3).
Big Parent Unit
• Connect the AC power adapter (17) to an AC mains socket, and then
connect the cord to the DC power supply socket (12) of the big Parent
Unit.
Note:To switch off the big Parent Unit completely, switch the Volume control -
on/off switch (14) to Off.
Small Parent Unit
The small Parent Unit uses a rechargeable battery pack.This is already
installed, but first it must be charged for at least 14 hours as follows before
using the unit outside the charging base:
1 Connect the AC power adapter (23) to an AC mains socket, and then
connect the cord to the DC power supply socket (30) of the charging
base (22).
2 Place the small Parent Unit inside the charging base.
The red charging light (28) lights.
> The small Parent Unit can be operated now but you should leave it in
the charging base until the batteries are fully charged (at least 14 hours).
When the batteries are fully charged, take the small Parent Unit out of
the charging base and use cordlessly for up to 12 hours.
> When the Power light (24) flashes green, the battery power is low. Place
the small Parent Unit inside the charging base to recharge the batteries.
Avoiding interference
• If there is interference or if sound reception is poor, switch all units to
another channel.
Always make sure that the Channel selection switches (5, 15, 26) on all
units are set to the same position.
Near a window, the Parent Unit picks up interferences from further away.
Move Parent Unit away from window.
ENGLISH 7
D
C
9
V
D
C
9
V
DC 9V
SYSTEM CHECK
LEVE L
CHARGE