Filter
Top Products
⇠ 17
Important! Not all seat belts work
the same way. To make sure that the
infant car seat is properly installed
using your seat belts, read your vehicle
owner’s manual. It will suggest proper
placement of an infant car seat in your
particular vehicle.
Park your vehicle on level ground.
1• Take the car seat off the base by
moving the handle to the upright
position. Place your hand on the top
of the seat back and pull up on the
handle with your fingers.
Note: Pulling near the center of the
handle provides the easiest release.
2• Position the base rear facing in the
back seat of your vehicle. Check the
level indicator on the side of the
base to make sure that the pointer
is in the green area. If it is not, turn
the knob left or right until it is in the
correct position.
II - How to Install the Base Using Your VEHICLE SEAT BELT
PrimoViaggioSIP-ES_USA_30-30_FIU17 17 10-03-2010 14:44:51