Filter
Top Products
⇠ 13
I USING THE LATCH
SYSTEM. If your car has
“universal lower anchors”,
you can install the infant
car seat using the LATCH
system instructions on page
14. The anchor is a bar located where
the seat back meets the seat bottom
(slide your hand down between the
seat back and seat bottom to locate
this bar).
Important! Also read your vehicle
manual for locating lower anchors
and instructions on using the LATCH
system.
II USING THE STANDARD LAP BELT/
SHOULDER STRAP. If your car does
not have universal lower anchors,
install the infant car seat using the
instructions for lap belt/shoulder
straps on page 17.
When using Primo Viaggio Sip ES 30•30 with its base, first you install the
base, and then you install the car seat on the base.
Important! Read your vehicle manual for instructions on where to best install an
infant car seat in your vehicle.
There are two ways to install the base:
Installing the Base
PrimoViaggioSIP-ES_USA_30-30_FIU13 13 10-03-2010 14:44:48