Filter
Top Products
pACK CONTENTS6
Connecting the parent unit
Position the parent with a minimum distance of 1 m to
other electronic devices, otherwise there is a risk.
!
ATTENTION
Operating with a power adapter plug
Connect the parent unit as illustrated in the diagram. For
safety reasons, only use the power adapter plug supplied.
Mains power outlet
Operation with rechargeable batteries
6. Turn the belt clip upwards.
7. Open the battery compartment on the rear side of the
parent unit.
8. Insert the batteries, paying attention to correct polarity.
9. Close the battery compartment again.
10. Turn the belt clip back downwards.
The parent unit is powered by a 3.6 V, 930 mAh battery pack.
The rechargeable battery pack can be recharged directly in
the parent unit when it is inserted in the charging station. The
Power LED lights up red when the parent unit is being charged.
In the case of a low battery charge, the Power LED flashes
slowly. The battery pack must then be recharged.
Using the belt clip/support
You can use the belt clip/support as a belt clip by turning it
upwards.
When tuned downwards, it can be used as a support to
keep it in a standing position.
Important Note
Before using your SC700 for the rst time, please charge
the batteries in the parent unit for a minimum of 14 hours.
This will help to increase the performance of your battery.