Filter
Top Products
8 OpERATING ThE pARENT uNIT
5 Operating the Parent Unit
Check the baby unit and parent unit are working properly each
time before the equipment is put into operation.
Switching the parent unit on/off
Press and hold this button until you hear 2 acoustic
signals. The logo appears rst then the image being
taken by the baby unit camera.
Press and hold the button for approx. 1 second to
switch the unit off.
In the case of a low battery charge, the Power LED flashes
slowly.
Setting the brightness
Press the button once.
This icon appears in the display for a few seconds.
Use this button to adjust the brightness to one of ve
settings.
Adjusting the temperature measurement
IMPORTANT INFORMATION
The ideal temperature for a baby to sleep is 16° - 18 °C. Please
set or adjust the room temperature accordingly.
Press this button twice.
This icon appears in the display for a few seconds.
Use the button to set temperature measurement to
OFF, °C or °F.
18°C The current temperature is displayed during the
temperature measurement, e.g. in °C.
Switching this night light on/off
Press the button three times.
This icon appears in the display for a few seconds.
Use this button to switch the night light on the baby
unit on or off.
Operating the Parent unit
Adjusting the VOX
1
sensitivity
The VOX
1
function (sound detection) causes the
system to start transmitting automatically from the
baby unit to the parent unit immediately a voice or
sound is detected.
Press this button four times.
This icon appears in the display for a few seconds.
Use this button to set VOX to OFF or adjust the
sensitivity to one of 5 levels. When one of the five
levels has been set, the VOX LED lights up red and
the display goes out after 10 seconds.
The display is reactivated when a sound is detected