Filter
Top Products
– 27 –
Custom Configuration
You can determine the configuration by specifying in detail the physical drives to be used and the
logical drive to be created. Select [Custom], and click on [Next]. A screen as shown below appears.
Select the drive to configure the array and click on [Add to Array]. You cannot add a drive to an
existing array while running the Wizard.
Select the drive for hot spare and click on [Add Spare] to add Hot Spare drives.
Even if it creates a hot spare and completes Wizard, it may not be displayed on a screen.
In that case, please click [Rescan].
Click on [Accept Array] if you approve the suggested configuration.
Click on [Reclaim] to clear the last configured array.
Click on [Next] to accept the proposed configuration. Follow the on-screen instructions to complete
the configuration process.
It is satisfactory although the following logs may be registered at the time of creation of an
array.
Source: MegaServ
ID: 6107
Description: CheckConsistency is COMPLETED.