Filter
Top Products
SECTION 6—FRONT RIGGINGS
Van Seat 24 Part No 1143195
Adjusting the Angle of the Manual Center Mount
Footrest
ƽ WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE:Forthisprocedure,refertoFIGURE 6.8onpage 23andFIGURE 6.9.
1. Engagethereleaseleverwithonehand
(notshown)andmovethecenter
mountfootresttothedesiredangle
withtheotherhand.
NOTE:RefertoFIGURE 6.8onpage 23for
thelocationofthereleaselever.
2. Disengagethereleaselever(not
shown)tolockthecentermount
footrestinthenewposition.
FIGURE 6.9 Adjusting the Angle of the
Manual Center Mount Footrest
Adjusting the Footplate Angle
After 2/14/07
NOTE:Forthisprocedure,refertoFIGURE 6.10.
1. Loosen,butDONOTremove,thetwo
rearmountingscrewsandside
mountingscrew.
2. Movethefootplatetothedesiredangle.
3. Tightenthetworearmountingscrews
andsidemountingscrewtosecurethe
footplateinthedesiredposition.
4. RepeatSTEPS1and2forthe
other
footplate.
FIGURE 6.10 Adjusting the Footplate
Angle - After 2/14/07
Footplate
Center Mount
Footrest
Center Mount
Front Rigging
Footplate
Side Mounting
Screw
Rear Mounting
Screws