Support User Manuals

Invacare PHWH93 Car Seat User Manual

Open as PDF

of 28

SECTION 6—FRONT RIGGINGS

Part No 1143195 19 Van Seat

3. Securelytightenthelugboltandlocknutthatsecurethelowerfootresttothefootrest

support.

4. RepeatSTEPS1‐3fortheoppositesideofthewheelchairfootrest,ifnecessary.

Replacing Heel Loops

NOTE:Forthisprocedure,refertoFIGURE 6.4.

1. Notethepositionofhexbolt,coved

washersandlocknutforreinstallation.

2. Removethehexbolt,covedwashers

andlocknutthatsecurethelower

footresttothefootrestsupport.

3. Removethelowerfootrest.

4. Removethephillipsbolt,spacerand

locknutthatsecuretheexistingheel

looptothelowerfootrest.

5. Slidetheexistingheelloopoffthe

lowerfootrest.

6. Replaceheelloop.

7. ReverseSTEPS1‐6toreassemble.

FIGURE 6.4 Replacing Heel Loops

NOTE:Whensecuringheellooptolowerfootrest,tightenthephillipsscrewandlocknut untilthe

spacerissecure.

Raising/Lowering Elevating Front Riggings

NOTE:Forthisprocedure,refertoFIGURE 6.5.

1. Performoneofthefollowing:

•Raising‐Pullbackonthereleaseleverandraisefrontriggingtothedesired height.

•Lowering‐Supportfrontriggingwithonehandawayfromthereleaselever.Push

releaseleverdownwardwithotherhand.

FIGURE 6.5 Raising/Lowering Elevating Front Riggings

Coved

Washer

Hex Bolt

Footrest

Support

Coved

Washer

Locknut

Lower

Footrest

Phillips Bolt

Locknut

Spacer

Heel Loop

Release

Lever

previous next