Filter
Top Products
SECTION 6—FRONT RIGGINGS
Part No 1143195 17 Van Seat
SECTION 6—FRONT RIGGINGS
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting
in or out of the wheelchair, make sure that the footplates on the front riggings are
in the upward position or moved out of the way.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
Installing/Removing Front Riggings
CAUTION
If front riggings are used, then the seat MUST be adjusted to the highest mounting
position - otherwise damage may occur.
NOTE:Forthisprocedure,refertoFIGURE 6.1.
Installing
1. Ifnecessary,removethefootboard.
Refertoowner’smanualshippedwith
thewheelchair.
2. Turnfrontriggingtotheside(open
footplateisperpendicularto
wheelchair)andpositionmounting
holesinthefrontrigginghingeplates
withhingepinsonthewheelchair
frame.
3. Installthefrontrigginghingeplates
ontothehingepinsonthewheelchair
frame.
FIGURE 6.1 Installing/Removing Front
Riggings
4. Pushthefrontriggingtowardstheinsideofthewheelchairuntilitlocksintoplace.
NOTE:Thefootplatewillbeontheinsideofthewheelchairwhenlockedinplace.
5. RepeatSTEPS1‐4foroppositesideofwheelchair.
Telescoping Front
Rigging Support
Front Rigging
Release Lever
Front Rigging
Hinge Plate
Hinge Pins