Filter
Top Products
Parts
30 309572ZAF
15F144 Hose Wire Jumper
Use the 15F144 Hose Wire Jumper to heat
only the major volume hose, in a wide ratio
system.
To build one complete 50 ft single side heated
hose bundle, order the following parts:
Install as follows:
1. Wrap hose wire jumper (100) around resin
hose (101) in a spiral fashion.
2. Connect resin hose wire (101a) to other
side of Power-Lock connector (100a); see
page 13.
3. Wrap FTS cable (102) around resin hose
(101) in a spiral fashion.
4. Twist hoses (101 and 105) together to pro-
vide strain relief.
5. Repeat steps 1-4 for each length of hose
(101). Connect hoses, electrical connec-
tors, and cables; see Connect Heated
Hoses, page 13.
6. Install one -Lock connector (100a) between
wires; see page 13.
7. Connect FTS with a Non-Heated Whip
Hose or Remote Mix Manifold, page 20.
Ref. Part Description Qty
100 15F144 JUMPER, hose wire 1
101 HOSE, resin, heated; 50 ft
(15.2 m) minimum; see tables
starting on page 4
1
102 24J523 CABLE, FTS 1
104 261670 FLUID TEMPERATURE
SENSOR; see page 25
1
105 pur-
chase
locally
HOSE, hardener, unheated; 50
ft (15.2 m) minimum; customer
supplied
1
106 pur-
chase
locally
CONNECTORS, fluid; as
required to complete assem-
bly; not shown
as
req’d
This hose must be used with an FTS and
cable to provide grounding.