Filter
Top Products
Installation
22 309572ZAF
Protective Covering
1. Wrap all fluid hose connections with electri-
cal tape.
2. Fold wire back on hose to ensure adequate
strain relief. Wrap all electrical connections
and cable connections with electrical tape
to protect them from pulling apart and abra-
sion.
3. Install protective cover (see Accessories,
page 32), or wrap hose bundle with duct
tape to protect foam.
4. For hoses that include the standard braided
protective scuff cover, unroll excess cover
over hose and electrical connections. Tape
securely.
5. For hoses that include Xtreme-Wrap pro-
tective scuff sleeve, pull just enough
excess length over hose and electrical con-
nections. Tape securely.
NOTE: Xtreme-Wrap protective scuff sleeve
will contract when heated. Use only as much
length as necessary to cover connections and
allow excess to remain slack.
F
IG. 15
Leave CAN cable connector (if used)
accessible at whip hose joint for connec-
tor to the Remote Display Module Kit (if
ordered).
TI2681A