Fisher-Price T4201 Car Seat User Manual


 
7
Setup and Use
To prevent serious injury or death:
Fall Hazard - Never use this product on an
elevated surface, since child’s movement may
cause the product to slide or tip over. Use
only on a floor.
Suffocation Hazard - Never use on a soft
surface (bed, sofa, cushion) since the
product can tip over and cause suffocation in
soft surfaces.
• Never leave child unattended.
Never use as a carrier or lift while child
is seated.
This product is not intended to replace a cot
or bed for prolonged periods of sleep.
Use the upright position (toddler mode) only
when child has developed enough upper
body control to sit without leaning forward.
Always use the restraint system until
child is able to climb in and out of the
product unassisted.
Do not use reclined position (infant mode)
once child can sit unaided.
• Never use toy bar as a handle.
WARNING
Infant - Recline
Kickstand
Kickstand
• Rotate the kickstand out for a stationary feeding seat.
• Push down on the seat bottom to be sure the kickstand
is in position.
2
Waist Belt
Restraint Pad
Restraint System
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the waist belts to each side of the restraint pad.
Make sure you hear a “click” on both sides.
• Tighten each waist belt so that the restraint system is snug
against your child. Please refer to the next section for
instructions to tighten the waist belts.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
3
Waist Belt
Seat Position
Fasten the straps on the back of the pad for the Infant-Recline Position.
1
BACK VIEW