Filter
Top Products
6
Battery InstallationAssembly
Hint: We recommend using an alkaline battery for longer
battery life.
• Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
+ -
1,5V
“D” (LR20)
• Locate the battery compartment on the bottom of the
vibrations unit.
• Loosen the screw in the battery compartment door. Lift to
remove the battery compartment door.
• Insert one “D” (LR20) alkaline battery.
• Replace the battery compartment door and tighten the screw.
• If this product begins to operate erratically, you may need to reset
the electronics. Slide the power switch off and then back on.
IMPORTANT! Low battery power causes this product to operate
erratically: no vibrations and the product may not turn off.
Remove and discard the battery and replace with a new
“D”(LR20) alkaline battery.
• Fasten both buckles on the front edge of the pad around the front
crossbar. Make sure you hear a "click" for each buckle.
10
Pad Buckles
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removeable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Battery Safety Information