Filter
Top Products
2
Type
1
Features
Forward-Facing Installation
24
LATCH Installation
Figure 1 illustrates a typical forward-facing
LATCH installation.
IMPORTANT! Verify that your vehicle is
equipped with lower anchors. If lower anchors
are not installed, you must use vehicle belt
installation methods (see pages 26–29).
1. Lift up cover from seat and remove
the lower
hook strap and lower hooks out of the rear-facing
belt path OR from the storage slots
(Fig. 2). Pull
hooks through forward-facing path (Fig. 3).
2. Press and hold the lower adjuster release
button, then pull to lengthen lower hook strap
to full length.
3. Verify that the lower hook strap is not twisted,
then attach the left lower hook to left lower
anchor in desired seating position (Fig. 4).
Pull on lower hook to confirm attachment to
lower anchor.
4. Verify that the lower hook strap is not twisted,
then attach the right lower hook to right lower
anchor in desired seating position. Pull on
lower hook to confirm attachment to lower
anchor.
1
2
4
3
25
Forward-Facing Installation
5
5.
Kneel on the restraint to push it into the
vehicle seat while pulling the lower hook strap
tight (Fig. 5).
6. Install tether as instructed on pages 32–33.
7. Verify that all connections are secure and the
restraint is stable. A secure restraint should
allow no more than 1 inch of side-to-side or
forward movement at the belt path.
LATCH Removal
1.
Press button on lower adjuster to loosen lower
hook strap (Fig. 6).
2. Press on tab to release hook from lower anchor.
3. Disconnect the tether.
IMPORTANT! When not in use, always
store the lower hooks in storage slots under
cover (see page 16, Fig 2).
6
4a
Always use in upright position in
forward-facing mode. See page 11.
WARNING