Filter
Top Products
FORWARD-FACING POSITION 1 YEAR AND UP (22 - 40 LBS.)
4"
4"
If a pre-drilled hole does not exist, you will
have to drill a
5
/
16
" hole. (Be sure to wear
appropriate eye protection when drilling.)
Make sure the hole is behind the vehicle seat
and still accessible by the tether strap; and
no more than 4" from the center line of the
Safe Embrace
®
Convertible Car Seat.
Insert the bolt through the anchor.
Insert the end of the bolt into the hole inside
your vehicle.
From the outside or underside of your vehi-
cle, attach the washer and lock nut to the
end of the bolt. While holding the bolt tight
with a wrench, tighten the lock nut securely
with another wrench. If the drilled hole is on
the floor of your vehicle, use a silicone caulk
to seal out water and exhaust fumes.
Bolt
Anchor
Washer
Lock Nut
Car Seat
Center Line
Hole is
behind
vehicle seat
and still
accessible by
tether strap.
4
B
6
B
7
B
5
B
Tether Anchor Installation
Van, Hatchback, Station
Wagon, Sport Utility Vehicle
42
Pages evens 12/15/99 2:45 AM Page 30