Filter
Top Products
Preparing Child Restraint to Fit
Your Child
2
3
Press on harness retainer
release button and pull
apart.
Loosen harness by pushing
down on the harness
release lever while pulling
out on harness.
You MUST make these adjustments with your child
before you install the child restraint in the vehicle.
Make sure LATCH belt
packaging is pulled free of
child restraint shell.
1
12
Rear-Facing Position:
Harness guide must be
even with or just below
the shoulders.
If the harness is above the
child’s shoulders with the
headrest in the lowest
position, do not use this
child restraint. Use an infant
child restraint instead.
Harness
Guide
7
Forward-Facing Position:
Harness guide must be even with or just above the
shoulders.
If the harness is below the child’s shoulders with the
headrest in the 4th highest position, the child weighs at
least 30 lbs. (14 kg) and is over 1 year old, convert the
seat to a belt-positioning booster. Refer to weight and
height chart.
Check Harness/Headrest Height
13
5
Place the child’s bottom and
back flat against the child
restraint.This will increase
comfort and allow the
harness to properly tighten.
continued on next page.
6
Determine which of the
three available buckle slots
is both comfortable and
snug. Refer to “Removal of
Harness” and “Removal of
Base” to adjust buckle.
For either style “A” or
“B”, press red button on
buckle to release the
buckle plates. Place
harness over sides of child
restraint.
4
A
B
4358-3340A Instrctions 11/15/04 9:18 AM Page 15