Filter
Top Products
28
With weakest hand at belt
path, tilt and push the child
restraint forward and back,
and from side to side. If
the seat belts do not
loosen, your child restraint
should be secure.
NOTE: Some “play” from
front to back or about an
inch from side to side is
acceptable. If it moves more, review “Knowing your Vehicle
Belts” and “The Locking Clip” sections.
After checking for hot seat and buckles, secure child as
described in “Securing Your Child in the Child Restraint”
section.
5
WARNING
!
Using the child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it can result in
serious injury or death.
4
Push down firmly on the
child restraint and pull up
on belt to tighten. For a
manual belt, refer to
“Knowing your Vehicle
Belt” section. Pull up on
shoulder strap to remove
any slack.
29
Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm).
Do not use the LATCH
system along with the
adult lap or lap/shoulder
belt.
To thread LATCH belts:
Pull the seat pad off the
front corners of shell.
1
Reach under pad, pull one
LATCH hook between
rear harness slot and
buckle strap.
LATCH adjuster can be
on either side, but belt
should not be twisted.
Route entire LATCH belt
through the upper slot in
side of shell.
2
3
Rear-Facing Installation with
LATCH: Install LATCH Belt
continued on next page.
NOTE: In some cases, you
may need to pull the pad off
the front corner and
expose the belt path.
Tighten belt through belt
path slot. Replace pad on
corner.
4358-3340A Instrctions 11/15/04 9:18 AM Page 31