Filter
Top Products
34
After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
Forward-Facing Installation
You may need to remove
the base for narrow vehicle
seats or airline use. See
“Removing Base” in Belt-
Positioning Booster
section.
NOTE: To install the child
restraint without the base,
rotate recline stand down
and out, then push up to
lock.
Loose LATCH hooks can result in serious
injury or death.
When LATCH is not being
used, fasten belt hooks
together behind the child
restraint as shown.
WARNING:
!
Forward-Facing Use: 20-40 lbs. (9-18 kg), 29-40” (73-102 cm), Over 1 year of age.
Forward-Facing Installation with
Vehicle Belts:
Face child restraint
forward in the vehicle
seat either in the reclined
or upright position.
Thread the vehicle lap
belt or lap/shoulder belt
combination through the
belt path and out other
side. Buckle.
1
2
Place one knee in the
child restraint and push
down firmly while pulling
up on belt to tighten. For
a manual belt, refer to
“Knowing your Vehicle
Belt” section.
Connect top anchorage
strap to the anchor
bracket.
To Adjust and other top
anchorage strap
information: See
“Adjusting Top Anchorage
Strap” section.
NOTE:
If your vehicle
does not have an anchor
bracket, tuck the top
anchorage strap and
hook under the base or
child restraint.
3
35
continue on next page.
4358-3340A Instrctions 11/15/04 9:18 AM Page 37