Filter
Top Products
34
35
4
Thread the harness down
through slot on left side
of shell (1), across bottom
of shell (2) and up through
slot on right side (3).
Thread one latch plate
onto harness from back
to front
(4). Thread the
harness retainer (5). Do
the same to the other
harness end. Make sure
the harness is not twisted.
Push harness ends through
upper slots in shell
(6).
WARNING
!
Failure to reattach the harness correctly,
can result in serious injury or death.
1
2
3
4
5
6
Fit loops on harness ends
onto the splitter plate.
5
continued on next page.
Removing Seat Pad for Cleaning
Remove harness as
described in the “Belt-
Positioning Booster”
section.
If your child restraint has
armrests,
pull armrest
covers off armrests and
pull through hole in back of
shell.
From underneath bottom
of shell, release the elastic
straps shown in red.
2
1
WARNING
!
Do not use this child restraint without
the seat pad. Failure to do this can
result in serious injury.