Filter
Top Products
Introduction 1-3
Figure 1-2 shows the standard features that you can see with the front bezel removed.
Table 1-2 describes the features that you can see after the front bezel is removed.
Reset Button This button is behind the front bezel so
that you cannot reset the filer inadvert-
ently. It enables you to reset the filer in
those rare cases when the system fails
or you upgrade the software.
To reset the filer, remove the front bezel
and push the reset button, located
below the power LED.
Diskette Drive This drive enables you to boot the sys-
tem from a diskette when the system
fails to start from the hard disk. You also
use this drive to run diagnostics using
the diagnostics diskette.
LCD (Liquid Crystal Display) The LCD displays status, error, and diag-
nostic messages up to 32 characters
long.
The LCD messages are described in the
section, “LCD messages,” in Chapter 3.
Reset
button
Diskette drive
LCD