Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 91780
2.
Figure 8
Motor
Motor Cables
(17s & 24s)
Bracket mounted to
Tie Bar (10w) ends
Solenoid
Assembly (34w)
Bracket
Tie-down
Strap (41w)
To attach the Solenoid Assembly/Bracket
to the Motor Assembly:
a. Slide the Bracket Tie-down Strap (41w)
over the hook in the center of the
Solenoid Bracket (40w).
b. Unthread the two Bolts (12-1w) and
Nuts (13w) from the motor end of the
Tie Bars (10w).
c. Rotate the Solenoid Assembly/Bracket
so that the holes on the side of the
Bracket line up with the end of the Tie
Bars (10w).
d. Re-insert and tighten the Bolts (12-1w)
and Nuts (13w), securing the Solenoid
Bracket to the Tie Bar.
e. Secure the Solenoid Bracket to the
Motor by tightening the Bracket Tie
Down Strap (41w) around both the
Solenoid Bracket hook and the Motor
Assembly. Pull the Strap until secure.
Wiring
TO PREVENT
SERIOUS INJURY
FROM EXPLOSION DUE TO
SPARKING AT THE BATTERY
CONNECTION:
Turn the Power Switch of the
winch off and disconnect the
power and control cables before
making wiring connections.
TO PREVENT
SERIOUS INJURY
FROM LEAKING BATTERY ACID:
Do not use a dirty, corroded or
leaking battery. Only use a 12V
automotive (or equivalent)
battery, in good condition.
1. Plan a route for the wiring from the
point of the vehicle where the winch
will be mounted or used to the battery.
This route must be secure, out of the
way of moving parts, road debris, or
any possibility of being damaged by
operation or maintenance of the vehicle.
For example, you may wish to route
the wires under the vehicle, attaching
it to the frame using suitable fasteners.
Do not attach the wires to the exhaust
system, drive shaft, emergency brake
cable, fuel line, or any other components
which may damage wiring through heat
or motion, or create a re hazard.
2. If you drill through the bumper or any
part of the body to route the wires, be
sure to install a rubber grommet in the
hole to prevent fraying of the wires at
that point.
3. Route the Battery Cables (13s & 16s)
from the point the winch will be used to
the battery, following the precautions
discussed above.
4. Attach the red Battery Cable (13s) to the
positive terminal on the battery.
5. Attach the black Battery Cable (16s) to
the negative terminal of the battery.