Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. SKU 91780
12. Attach the Switch Assembly (35w) to the
Socket (6s) on the Solenoid Assembly
(34w).
13. When it is safe to do so, use the button
on the Switch Assembly to retract the
wire rope, and winch the item as desired.
Do not power the hook all the way
into the fairlead to prevent damage.
14.
45°
45°
15°
15°
Do not operate the winch at extreme
angles - do not exceed the angles shown
above. Pay attention to how the wire
rope is coiling onto the drum. If it is
building up on one end of the drum, stop,
uncoil the wire rope and recoil it from a
less severe angle to prevent damage.
If the object to be pulled must be pulled
at an angle in relation to the winch, use
a pulley and an anchor point directly in
front of the winch, as shown, to keep the
cable pull straight.
15. WARNING! Stop the winch and release
tension on the wire rope before moving
the rag or carpet placed on it.
16. Do not continue use of the winch until
the battery is completely run down. You
may wish to keep the engine running
while using this winch, to continually
recharge the battery. However, exercise
extreme caution when working around a
running vehicle.
CAUTION Do not use the winch in a
constant duty application, it is
designed for INTERMITTENT USE
ONLY. Keep the duration of the
pulling job as short as possible. If the
motor becomes very hot to the touch,
stop and let it cool down for several
minutes. Do not pull for more than
one minute at or near the rated load.
Do not maintain power to the Winch if
the motor stalls. Double Line Rigging
will help prevent overloading and
should be used whenever practical.
17. When nished pulling the load, reverse
the direction of the winch just enough to
release tension on the Cable Assembly
(36w) so that you can unfasten the Hook
from the load and reel in the cable.
18. To prevent accidents, turn off the winch
and disconnect its power supply after
use. Clean, then store the winch indoors
out of children’s reach. If the cable is
wet, dry it then apply light oil right after
use.