Filter
Top Products
Getting Ready
EN-57
English
7.
Connect the cable to the speaker jack and
secure the cable with the clips
J
.
• If you are using the Digital Piano in a stand-alone
configuration (not mounted on its stand), be sure to
change the “External Speaker” SYSTEM SETTING
to Off. For details, see “SYSTEM SETTING Screen”
under “Configuring Digital Piano Settings” (pages
EN-41 through EN-48).
8.
Plug the power cord of the AC adaptor that
comes with the Digital Piano into a household
power outlet as shown in the illustration
below.
Use the anti-tipping brackets to protect the stand from
tipping over when it is in a location that is not against a
wall, etc.
1.
Remove the bracket screws from the inside
surfaces of the side panels (two screws each
panel, four total) and then shift the position of
the brackets as shown in the figure.
2.
Replace the screws you removed in step 1
above and secure the brackets in place.
J
Household power outlet
AC adaptor
Power cord
Using the Anti-tipping
Brackets
Screws
Inside surface of
side panel
Screws
Inside surface of
side panel
CGP700-ES-1A.indd 59 2015/04/03 15:59:49