Filter
Top Products
20
Lap-Shoulder Belt Installation
Figure A illustrates a typical forward-facing lap-•
shoulder belt installation.
When not in use, always store the LCS connectors in •
storage slots. See page 29.
Place the child seat forward-facing on the vehicle 1
seat. Ensure the bottom of the child seat base is in
full contact with the vehicle seat.
Remove the Versa-Tether from the pouch and 2
place it up and over the child seat back.
Rotate the lock-off lever to open the forward-3
facing lock-off farthest from where the vehicle
belt will be buckled.
Pull the vehicle belt out, then pass it through the 4
forward-facing belt path (Fig. B) to the opposite
side of the child seat.
Verify that the vehicle belt is not twisted and then 5
buckle (Fig. C).
Push the child seat firmly into the vehicle seat 6
while removing slack first from the lap portion of
the vehicle belt, then from the shoulder portion (Fig. D).
Installation : Forward-Facing
D
b
C
A
Forward-Facing
WARNING!
This child seat must not be used forward-facing •
for children less than one year of age OR who
weigh less than 9.1 kg (20 lbs).
This child seat must be in the upright position •
when installed forward-facing.
Always use the Versa-Tether when the child •
seat is installed forward-facing. Check your
vehicle owner’s manual for approved tether
anchor locations.