Filter
Top Products
19
Attach the closest LCS connector to the farthest 6
LUAS anchor (Fig. D).
Check that the LCS connector strap is not twisted, •
and that the LCS connectors are in an upright
position (Fig. E) to ensure proper installation.
NOTE: It may be necessary to switch LCS connectors
as shown on page 28 if ANY of the following
conditions exist :
The LCS connector is • not in an upright position
(Fig. E).
The LCS strap is twisted.•
A positive click is • not heard when LCS connector and
LUAS anchor are connected.
NOTE: If a positive click is not heard, but the LCS
connector is in an upright position, you should not
switch the LCS connector. The strap may be too tight or
twisted, or there may be debris in the LCS connector.
Rotate the child seat into the forward-facing 7
position. Ensure the bottom of the child seat base
is in full contact with the vehicle seat.
Attach the remaining LCS connector to the 8
adjacent LUAS anchor (Fig. D).
Push the child seat into the vehicle seat while 9
pulling each LCS adjuster strap tight (Fig. F).
Attach the Versa-Tether10
®
hook to the designated tether anchor for the
chosen seating position. Remove all the slack from the tether to secure.
Store any excess webbing in the tether pouch. See pages 25 – 27.
Verify that all connections are secure and that the child seat is stable. 11
The child seat is secure when it cannot be moved front-to-back or side-to-•
side more than 2.5 cm (1 in.) at the belt path. If the child seat is not secure,
repeat the procedure or use an alternate seating location.
Installation : Forward-Facing
D
f
e
Top
Release
Button