Filter
Top Products
13
The LCS connector is • not in an upright position
Fig. D).
The LCS strap is twisted.•
A positive click is • not heard when the LCS
connector and LUAS anchor are connected.
NOTE: If a positive click is not heard, but the LCS
connector is in an upright position, you should not
switch the LCS connectors. The strap may be too
tight or twisted, or there may be debris in the LCS
connector.
Push the child seat firmly into the vehicle seat 8
while pulling the LCS adjuster strap tight (Fig. F).
Verify all connections are secure and that the 9
child seat is stable.
The child seat is secure when it cannot be moved more •
than 2.5 cm (1 in.) front-to-back or side-to-side at the
belt path. If the child seat is not secure, repeat the
procedure or use an alternate seating location.
When properly installed in the rear-facing position, the •
back angle of the child seat should be 30º – 45º from
vertical (not to exceed 45º) when the car is parked on
a level surface (Fig. G).
If necessary, the proper recline angle can be achieved •
by placing a rolled towel or pool noodle in the crease
of the vehicle seat to level the child seat’s base.
Rear-facing installation can be improved by the use of the Versa-Tether. See •
pages 25 – 27.
Installation : Rear-facing
e
f
30–45º
0º
90º
G
WARNING! Do not raise the child seat off the front edge of the
vehicle seat. This could cause your child seat not to perform as
intended.