Filter
Top Products
32
33
Loosen the harness by pressing the harness 1
adjuster release button while pulling the
harness straps forward as far as possible.
Unhook the harness straps from the harness 2
yoke on rear of child seat (Fig. E).
Pull the upper harness straps through the 3
shell and cover to the front of child seat.
Remove the harness buckle and belly pad by 4
turning the metal buckle strap retainer of the
harness buckle on the underside of the child
seat so the short side will slide through the
child seat shell (Fig. F).
Gently remove the upper portion of the 5
cover. Be careful not to damage the energy-
absorbing foam.
Push the metal buckle strap retainer through the slots in the 6
shell and cover to the top of the child seat.
Pull the lower harness straps, buckle tongues, and chest clip 7
through lower slots in cover.
Remove the entire cover from child seat.8
Child Seat Cover Removal
Position harness straps around the child and fasten 6
the harness buckle (Fig. A) and chest clip (Fig. B).
Proper connection of the harness buckle is confirmed •
with a positive click after inserting each buckle
tongue.
If the buckle will not fasten with a positive click after •
inserting each buckle tongue, the harness buckle or
adjuster area may be clogged with food, drink or
other debris that needs to be removed. See page 36
for cleaning instructions.
IMPORTANT: Gently pull up on the harness straps
to tighten lap section of the harness which should fit
across the child’s upper thighs.
Slowly pull the adjuster strap to tighten the 7
harness around the child (Fig. C).
Position the chest clip at the middle of the child’s 8
chest, level with the armpits (Fig. D).
Verify that harness is not twisted and child is 9
properly secured.
IMPORTANT:
Always pull on the harness after securing the child to •
ensure the buckle tongues are secure in the harness
buckle.
Adjust the belts provided with this child seat so they •
fit snugly around your child. A snug strap should not
allow any slack. It lies in a relatively straight line
without sagging. It does not press on the child’s flesh
or push the child’s body into an unnatural position.
The harness should have a comfortable but snug fit
around the child. You should not be able to pinch
excess webbing at the shoulder once the harness is
properly secured.
Child Seat Functions
A
b
c
d
Care and Maintenance
e
f
WARNING!
Do not take apart the harness. Never remove
the buckle tongues from the harness. They cannot be reattached
after removal. If reassembled incorrectly, the child seat may not
perform as intended.