Filter
Top Products
20
21
Lap-Shoulder Belt Installation
Figure A illustrates a typical forward-facing lap-•
shoulder belt installation.
When not in use, always store LCS connectors in •
storage slots. See page 28.
Place the child seat forward-facing on the 1
vehicle seat. Ensure the bottom of the child seat
base is in full contact with the vehicle seat.
Remove the Versa-Tether from the pouch 2
and place it up and over the child seat back.
Pull the vehicle belt out then pass it through the forward-facing 3
belt path to the opposite side of the child seat (Fig. B).
Verify that the vehicle belt is not twisted, then buckle (Fig. C).4
Rotate lever downward to open the forward-facing lock-off 5
farthest from where the vehicle belt is buckled.
Push the child seat firmly into the vehicle seat while first 6
removing slack from the lap portion of the vehicle belt and then
the shoulder portion (Fig. D).
Hold the shoulder belt tight and rotate 7
the lock-off until the vehicle belt is secured
(Fig. E).
If your vehicle is equipped with an automatic locking •
retractor (ALR), use of the lock-offs is not required
as long as the ALR is locked. Check your vehicle
owner’s manual to determine what type of retractor
your vehicle has, and how to lock the retractor.
Attach the Versa-Tether8
®
hook to the
designated tether anchor for the chosen
seating position. Remove all slack from the
tether to secure. Store excess webbing in the
tether pouch. See pages 25 – 27.
Verify that the vehicle belt is tight and that 9
the child seat is secure.
The child seat is secure when it cannot be moved front-to-back or side-•
to-side more than 2.5 cm (1 inch) at the belt path. If the child seat is not
secure, repeat the procedure or use an alternate seating location.
Installation : Forward-Facing Installation : Forward-Facing
d
b
e
c
A
Forward-facing
WARNING!
This child seat must NOT be used forward-•
facing for children less than one year of age OR
who weigh less than 9.1 kg (20 lbs).
This child seat must be in full upright position •
when installed forward-facing.
Always use the Versa-Tether when the child seat •
is installed forward-facing. Check your vehicle
owner’s manual for approved tether anchor
locations.