Filter
Top Products
18
19
Place the child seat sideways in the upright 4
position on the vehicle seat with the back of the
child seat facing you.
Remove the Versa-Tether from the pouch and 5
place up and over the child seat back.
Verify that the LCS strap is not twisted and attach 6
the closest LCS connector to the vehicle seat back
to the farthest LUAS anchor (Fig. B).
A positive click confirms attachment.•
NOTE : It may be necessary to switch LCS connectors
as shown on page 28 if ANY of the following
conditions exist :
LCS connector is not in an upright position (Fig. D).•
LCS strap is twisted.•
A positive click is NOT heard when the LCS connector •
connects to the LUAS anchor.
NOTE : If a positive click is not heard, but the LCS
connector is in an upright position, you should not switch the LCS connector. The
strap may be too tight or twisted, or there may be debris in the LCS connector
.
Rotate the child seat into the forward-facing position. 7
Verify that the LCS strap is not twisted and attach the remaining LCS 8
connector to the adjacent LUAS anchor (Fig. D).
A positive click confirms attachment• .
Push the child seat into the vehicle seat while pulling the LCS adjuster 9
strap tight (Fig. F). Ensure the bottom of the child seat base is in full
contact with the vehicle seat.
Attach the Versa-Tether10
®
hook to the designated tether anchor for the
chosen seating position. Remove all slack from the tether to secure. Store
any excess webbing in the tether pouch. See pages 25 – 27.
Verify all connections are secure and that the child seat is stable. 11
The child seat is secure when it cannot be moved front-to-back or side-to-side •
more than 2.5 cm (1 inch) at the belt path. If the child seat is not secure, repeat
the procedure or use an alternate seating location.
Lower Universal Anchorage System (LUAS) Installation
Figure A illustrates a typical forward-facing LUAS •
installation.
Verify that your vehicle is equipped with LUAS •
anchors. If LUAS anchors are not available, you must
use vehicle
belt installation methods.
IMPORTANT: Check that the LCS connector strap is
tight and not twisted, and that the LCS connectors
are in an upright position (Fig. B) to ensure proper
installation.
Remove the LCS connectors from storage slots 1
under the cover. See page 28. Pull both LCS
connectors completely through the child seat’s
right-side, rear-facing belt slot (Fig. C) so they
are on the outside of the shell.
NOTE : Child seat is assembled in rear-facing
mode.
Press and hold one LCS adjuster release button, 2
then pull to extend the LCS strap to full length.
Repeat on the other end of the strap.
Thread the appropriate LCS connector through 3
the forward-facing belt path (Fig. D) at the back of the child seat.
Installation : Forward-Facing Installation : Forward-Facing
c
e
d
b
Top
Release
Button
WARNING!
This child seat must NOT be used forward-•
facing for children less than one year of age OR
who weigh less than 9.1 kg (20 lbs).
This child seat must be in full upright position •
when installed forward-facing.
Always use the Versa-Tether when the child seat •
is installed forward-facing. Check your vehicle
owner’s manual for approved tether anchor
locations.
A
Forward-facing
f