Filter
Top Products
22
23
Attach the Versa-Tether6
®
hook to the designated tether anchor
for the chosen seating position. Remove all slack from the
tether to secure. Store excess webbing in the tether pouch. See
pages 25 – 27.
Verify that the vehicle belt is tight, locked, and child seat is 7
secure.
The child seat is secure when it cannot be moved front-to-back or side-•
to-side more than 2.5 cm (1 inch) at the belt path. If the child seat is not
secure, repeat the procedure or use an alternate seating location.
Lap-Belt Installation
Figure A illustrates a typical forward-facing, lap-•
belt installation.
When not in use, always store the LCS connectors •
in storage slots. See page 28.
Place the child seat forward-facing on the 1
vehicle seat. Ensure the bottom of the child
seat base is in full contact with the vehicle
seat.
Remove the Versa-Tether from the pouch 2
and place it up and over the child seat back.
Pull the vehicle belt out, then pass it through the forward-facing 3
belt path to the opposite side of the child seat (Fig. B).
Verify that the vehicle belt is not twisted, then buckle (Fig. C).4
Push the child seat firmly into vehicle seat while tightening the 5
vehicle belt.
Installation : Forward-Facing Installation : Forward-Facing
b
c
A
Forward-facing
WARNING!
This child seat must NOT be used forward-•
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
This child seat must be in full upright position •
when installed forward-facing.
Always use the Versa-Tether when the child •
seat is installed forward-facing. Check your
vehicle owner’s manual for approved tether
anchor locations.