Filter
Top Products
Switching the LATCH Connectors
17
B
C
A
The LATCH harness must be
switched for proper alignment
in rear facing or forward facing
installations. The seat is sup-
plied with the LATCH harness
fitted in the rear facing posi-
tion. To switch the harness to
the forward facing position,
follow the instructions below:
1
Feed the complete latch har-
ness out through the seat on
the side with the short connec-
tor strap (
fig A
).
2
Then feed the LATCH con-
nector with the “For use on
Driver's side Latch Anchor”
label first, through the seat
shell as shown (
fig B
).
Connector labelled, “For use
on Driver's side Latch Anchor”
must be on appropriate side of
child restraint. Verify that har-
ness is not twisted.
3
To move from forward facing
to rear facing, reverse the
above procedure.
FAGalaxy_page proof 2/9/02 4:03 PM Page 17