Filter
Top Products
Installation: Rear Facing
15
Rear Facing Lap Belt Installation
1 Recline child restraint as necessary to
align leveling line horizontal with the
ground.
IMPORTANT:
Only use super recline
mode if necessary to obtain proper
angle, based on vehicle seat contour
(see page 29).
2 Unhook hook and loop attachments on
the front edge of the cover, then pull the
stabilizing bar out completely. Pull stabiliz-
ing bar upward until it clicks into position
(fig. A).
IMPORTANT:
Stabilizer bar must always
be extended when seat is rear facing.
NOTE:
Do not reattach cover with hook
and loop until seat belt has been rout-
ed.
3 Place the child restraint rear facing on
the vehicle seat.
4
Fully extend the vehicle seat belt, then
pass it through the closest rear facing belt
slot.
5
Route belt in front of the buckle strap, then through the second rear
facing belt slot
(fig. B)
.
6
Fasten the seat belt, then verify that the seat belt is not twisted
(fig. C).
A
B
C
FAGalaxy_page proof 2/9/02 11:17 AM Page 15