Filter
Top Products
3701 Phone User Guide Page 3
IP Office 3.2 [15-601083] Issue [1b] (1 June 2006)
Installation
Installation Location
Place the charger on a flat, even surface. Do not install the charger, phone and accessories in the
proximity of:
Water, moisture or damp areas.
Sources of heat, direct sunlight or unventilated areas.
Devices which generate strong magnetic fields, electrical appliances, fluorescent lamps,
computers, radios, televisions or fax and telephones.
Areas where the phone can be covered, its ventilation is impaired and liquid can get inside.
Areas where there is excessive dust and areas subject to vibration, shock or extreme
temperature fluctuations.
Install/keep the phone and accessories out of reach of small children.
Commissioning your Telephone
Your phone is only operational after the batteries have been charged. You can then use the phone to
make and receive calls.
Placing the batteries in the telephone
The battery compartment is on the back of the phone. It takes the three type AAA batteries, which are
supplied.
Opening the battery compartment cover: Insert
a suitable item (e.g. the top of a ballpoint pan)
into the hole at the bottom of the compartment
cover(1). Push it in and lift the cover at the
same time (2).
Inserting the batteries:
Insert the batteries in the battery compartment,
taking care to observe the correct polarity. The
+ - poles of the batteries must correspond to
the + - markings in the battery compartment.
Closing the battery compartment cover:
Replace the cover by placing it on the
compartment at a slight angle (1) and pressing
it down until it clicks into place (2).
Note
If the batteries are inserted incorrectly,
the phone will not function, and may be
damaged.