Filter
Top Products
6 78-0013-4441-1-D
3M
™
One Pass Mini Fiber Pathway
• Do not remove duct from box. Route end through handle
as shown and pay off duct.
6.0 Exposing Fiber For Termination
Expose 2-4' (610-1220 mm) of fiber from the end of the
duct before terminating using the following method:
6.1 Snip the flange on either side of the duct, being
careful not to cut the fiber in the duct.
Cut flange on both
sides of duct
Do not cut into
fiber inside duct
6.2 Twist the section to be removed 180°.
6.3 Pull the two sections of duct apart to expose the
fiber.
Pull straight
apart
7.0 Wall Outlet Installation
The beginning and the end of the One Pass Mini Fiber
Pathway must be held down mechanically. This is
accomplished with the cover of the wall outlet box and the
Point-Of-Entry Wall Cover base. If for any reason these
accessories are not used at the beginning and end of the
duct run, use of the adhesive backed mechanical anchor or
equivalent is required.
7.1 Attach the wall outlet base to the wall using two
screws (and anchors if necessary).
7.2 There are 12 ways to route the One Pass Mini
Pathway Duct into the Wall Outlet. Select one and
remove the break-away tab.
Breakaway tab locations