Filter
Top Products
10 78-0013-4441-1-D
3M
™
One Pass Mini Fiber Pathway
14.0 Connector Termination and Final Steps
14.1 Terminate the fiber using a 3M
™
No Polish
Connector or 3M
™
Crimplok+ Connector.
Anchor furcation tubing
Feed through from living unit
3M
™
One Pass Point-of-Entry Box (Hallway Side)
14.2 In buildings where the One Pass Fiber Pathway is
not the horizontal cable pathway solution, terminate
the hallway distribution cable (once a penetration
hole is drilled) inside the living unit in a Point-of-
Entry Box. Both the One Pass Mini Fiber Pathway
and horizontal distribution cable will terminate here.
3M
™
One Pass Mini Fiber Pathway
Horizontal Distribution Cable
Anchor Point
900-micron side Jumper side of box
14.3 After completing installation of the entire run of
duct and terminating the connector, route the 900 µm
fiber and install the connector in the adapter as
shown.
900 µm Fiber
Connector
Adapter
Snap
Locations
14.4 Attach the cover by aligning the bottom tabs to slots
in the base of the box, and then snap the cover in
place.
14.5 The tabs on the cover will hold the duct in place.
Tab secures duct
14.6 Align the connector to the adapter and plug. Slide
the door closed.